2100 Series Flow Modules
Teledyne ISCO’s 2100 Series offers flexible, modular design and easy configuration for a wide range of networked open-channel flow monitoring applications, including Inflow and Infiltration studies, CMOM and AMP data collection, and river monitoring.
Compact, stackable, NEMA 4x, 6P (IP68) modules snap together to provide the capabilities needed for practically any site and monitoring requirement.
2160 LaserFlow® Area Velocity Module
The 2160 LaserFlow Module uses non-contact Laser Doppler Velocity technology and non-contact Ultrasonic Level technology to remotely measure open-channel flow. The sensor has advanced technology to measure velocity with a laser beam at single or multiple points below the surface of the wastewater stream.
2150 Area Velocity Module
The 2150 Flow Module uses continuous wave Doppler technology to measure mean velocity. The sensor transmits a continuous ultrasonic wave, then measures the frequency shift of returned echoes reflected by air bubbles or particles in the flow.
2110 Ultrasonic Flow Module
The 2110 Ultrasonic Module provides accurate non-contact liquid level measurement, using built-in software to calculate flow in weirs, flumes and streams. When used in conjunction with Teledyne ISCO’s Flowlink® data handling software, that information can be managed and used in a wide variety of ways.
2103Ci CDMA Cellular Modem Module
This cellular modem module is designed to push Teledyne ISCO 2100 Series flowmeter data to a remote Flowlink® database. Data can also be downloaded from the server using an internet connection. The 2103Ci modem module uses Serial Over Internet Protocol (SOIP), so a landline modem is not required.
2103Gi GSM/GPRS Cellular Modem Module
This cellular modem module is designed to push Teledyne ISCO 2100 Series flowmeter data to a remote Flowlink® database. It virtually eliminates the need for recurring site visits, time-consuming (and potentially dangerous) confined space entry, as well as costly installation of land lines.
2105 Network Interface Module
The 2105 Interface Module is a powerful solution for environmental monitoring professionals to interface different monitoring and recording instruments.
The 2105 will monitor the recorded data and take intelligent actions, such as sampler enabling, pacing, and/or alarm generation, based on user-specified conditions.
2108 Analog Output Module
The 2108 Output Module provides three independent current outputs for ISCO 2100 Series Area Velocity Flow modules; the 2150, 2151, and 2151P. The 2108 is DIN Rail mounted and uses a 7-26V DC power supply.
It provides an easy interface from ISCO’s advanced 2100 Series Area Velocity Modules to data collection systems like SCADA/DCS or any other secondary instrument systems.
2150EX Flowmeter for Zone 0 Locations
The 2150EX is an intrinsically safe Area Velocity Flowmeter that is specifically designed and Baseefa-approved for use in Zone 0 and Zone 1 potentially explosive atmospheres under ATEX Directive 94/9/EC.
The AV 2150EX smart Area Velocity probe is built on digital electronics, so the analog level is digitized in the sensor itself. The probe is also factory-calibrated for 3 meter span at different temperatures. This superior built-in calibration eliminates temperature drift in the level signal, providing long-term level stability that reduces recalibration frequency and completely eliminates span recalibration.
The 2150EX is powered by the by the 2194EX network interface module for permanent, AC-powered installations, or by the 2196EX battery module for portable use. Highly efficient power management provides battery life of 6.5 weeks at a two-minute data storage interval.